How to Install LED Lights in Car Exterior?

LED lights are one of the easiest ways to customize the look of your car. If you are prone to drive more after dusk and before dawn, then you are aware of why you need to put LED lights in your vehicle. It can save you a lot of trouble if you do it the right way. Installing the lights takes a few hours at best, and here we will show you how.

Things You Will Need

You will need an assortment of tools and materials to install LED lights on the exterior of your car.

  • Strips of LED Lights
  • Zip ties
  • Cross Head Screwdrivers
  • Adhesive
  • Lead-Free Solder
  • Drill
LED Lights in Car Exterior

Installation Process

Once you have gathered all the necessary tools, we start the installation process. Again, the process is relatively easy for those who have had experience in soldering.

Setting up the LED Lights

It is essential that the LED lights you are going to use actually work. To test the LED lights, just plug them up to a power source and make sure they are fully functional. You will notice that the lights come with plastic clips. Use the clips to firmly attach the lights to wherever you want.

Distinguish Your Car’s Wiring System

In order to identify the negative and positive ends of the battery, you can just use the wiring diagram. It is a rule of thumb that the darker colored wires are connected to the negative end, and the lighter wires are connected to the positive.

Set Up the Wires for Installation

After distinguishing which wires are negative and which are positive, you can use a wire stripper to cut open and expose the metallic strands. It is advisable to use gloves when handling these wires as they contain potential energy.

Soldering the Wires

You will need long strands of wires that can run through the panels of your car. For that, you need a soldering iron to connect the extensive wires. Before going to the next step, make sure to test them out.

Cutting Holes in the Car

For a firm placement of the LED lights, you will need to drill a few holes through your car. You need to make sure to avoid the plastic parts and drill through the metallic ones. Needless to say, the holes themselves need to be slightly wider than the strips of LED lights. But if the gap is too big, your car is likely to get damaged by moisture.

Placing the Wires Through the Holes

After drilling the holes, you are going to have to run the wires through them. If the wires don’t fit properly, you can cut up the insulation slightly but cautiously. Run them through one at a time to make sure they don’t jam up.

Connecting the Wires

Now it’s time to connect the wires to the LED lights. You can use electrical tape or any kind of glue to make them connected. You have to make sure no loose wires are hanging around.

Use the Car Battery as the Power Source

The car battery will work as the primary power source for your lights. Connect the positive and negative ends of the wires carefully to the nodes of the battery. The wire used for this should be a lot thicker. After plugging them directly into your car battery, you can just test them out yourself.

Final Note

The installation process of LED lights may seem tedious, but it is worth it in the end. It also shows how passionate you are about your car. LEDs are known for their affordability and their low consumption of electricity. The practicality of these lights in the exterior of vehicles goes a long way.

Click Here to Leave a Comment Below 0 comments

Leave a Reply: